Club Car are one of the most popular brands in golf carts and the Precedent model is a staple here at Pete’s Golf Carts. We’ve sold several versions over the years and have expert advice for every part and spare you might need to keep yours running.

Installing the dash cover

Note

ATTENTION: IF YOU HAVE / OR IF YOU ARE ADDING LIGHTS — When you get to Step 6, if you have lights remove the switch from the key plate then place the key plate back into position. Slide the dash down the steering column into place. Drill a 1/8” pilot hole through the new dash and key plate. Remove the dash and drill out the hole to 9/16”. Drill the hole out on the key plate to 1/2” and install the switch. Now your dash is ready for the light switch.

Safety

Attention: Read all of the following safety and service instructions before attempting installation. Wear safety glasses during installation. Use extra tools as required for installation.

Step-by-step

1. Remove the screws behind the steering wheel and remove steering wheel cover.
2. Remove the steering wheel main bolt and remove the steering wheel. In order to remove the steering wheel slight force may be necessary by hitting the back side with a rubber mallet.
3. Remove the 4 torx bolts on the dash trim and remove the dash trim.
4. Place the Dash divider into the right side of the dash and secure with 2 screws at the bottom.
5. Slide the drink holder cover over the drink holder and screw into place with 2 screws. Repeat for other side.
6. Slide the main dash down through the steering column hole and place the upper lip of the dash behind the stock plastic on the top.
7. Slip the dash snugly into place. Pull carefully on the plastic along the bottom of the dash to slip it over the sensor.
8. Make sure the sensor is placed through the hole on the underside of the dash.
9. Open the glove box and squeeze the top plastic and glove box together while screwing in 2 screws into the top lip of the dash.
10. Secure the glove box by placing 3 screws along the bottom edge of the door.
11. Place 2 screws into the right side of the glove box as shown.
12. Place 3 screws under the dash as shown.
13. Secure the left side of the dash with 2 screws as shown. Then re-attach the dash trim piece and the steering wheel and your done.

This completes the installation of the Club Car Precedent Dash.

Get the kit

Buy Your New Club Car Precedent Golf Cart Dash Cover Kit Today